![]() Use at your own risk and provided “AS_IS. The script provided is purely experimental, distributed as experimental, and should be used as such. As always, I do not take responsibility for any damage, issues, misuse, unexpected outcomes, etc. Gotta pay the bills, right?Īgain, I tested with my Elecraft KX3 and worked like a champ! Good Luck! Give me some time to respond as I go days without checking personal email depending on what is going at work. If you need some help, email me and I will do my best to try and help. You can also use command line to get files directly onto the Pi. ![]() If you need some help on trying to figure out how to get this script onto your Raspberry Pi, look into WinSCP as an option. Grab a drink, some food, walk the dog, etc.ĥ.) This has been tested on a Raspberry Pi 3 model and takes about 45 minutes to an hour from start to finish depending on how many updates you have to install for the packages as well as how fast your Internet connection is. Feel free to edit the script however you would like if you wish to change that….Ĥ.) Now watch the magic happen…. A powerful feature of the Raspberry Pi is the row of GPIO (general-purpose input/output) pins along the top edge of the board. pi3-fldigi-setup.sh – This will create a folder named “HamPi-FLDIGI” in your home directory. So, without further delay, you can download the new script here: pi3-fldigi-setup.shīelow are the instructions which are really no different than the original instructions:ġ.) Download the script here into your home directory logged in as “pi”:Ģ.) Run the following command to make the script executable: sudo chmod +x pi3-fldigi-setup.shģ.) Now execute the script: sudo. This time I am assuming you have a newer NOOBS version installed and already functional on your Raspberry Pi. ![]() It was no easy task for me as I am not super savvy with scripting and compiling code, but very exciting to see it being used all over the world. I appreciate everyone who has reached out and thanked me for the work I put into this script. We mark /dev/ttyAMA0 (the serial link of the Raspberry PI is located on the GPIO pins of the 40-pin connector) If the USB / RS232 cable reserved for the CAT-System is connected, a new line appears. It is finally here! After repeated requests to enhance my first installation script used to install FLDIGI on a Raspberry Pi, I have sat down and focused on updating everything so you get the latest HAMLIB package for rig control etc. Part 2 : Traffic software Installation FLDIGI, WSJT-X etc. Install Script for FLDIGI that includes compiled RigControl HamLibs using version FLDIGI 3.23.13 – BONUS: Verified and tested on Raspberry Pi 3.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |